The installation of vehicle monitoring system

The installation of Vehicle Monitoring System mainly includes: vehicle video terminal, camera and pickup installation, cable laying, wiring four parts

1. Vehicle video terminal installation:

The vehicle video terminal must be firmly fixed when installed.

In order to extend the life of the equipment, please install the equipment in parts of the vehicle with weak vibration as much as possible, such as the back of the driver's seat or the front of the vehicle, and pay attention to the installation position that cannot affect the normal operation of the driver.

The equipment should be installed in the ventilated part of the vehicle: the equipment installed on the plane should be kept at a certain distance from other objects to facilitate the circulation of air and heat dissipation; Cannot be installed in enclosed spaces (e.g. vehicle toolboxes). It cannot affect the heat dissipation of the device.

The external wiring rod of the equipment should have sufficient spacing and protection to ensure that the wire is not bent or leaked due to vibration wear;

Keep the device away from heat sources on the vehicle.

The device is installed horizontally, and any other angle of installation will damage the device.

When choosing a mounting location, consider the amount of space pulled out of the enclosure.

2. Camera, pickup installation

The installation of cameras and pickups is determined according to the customer's monitoring focus.

Camera installation location selection principles:

Cover the scenario that needs to be monitored

The camera is easy to install and fix

The wiring of the camera is convenient

The camera is not easy to be occluded and destroyed

Consider environmental influences such as backlighting that the camera will be exposed to

3. Cable laying

The wiring of the vehicle monitoring system is very important, whether the wiring is standardized will be directly related to the reliability and stability of the operation of the system, pay attention to the following before construction:

The cables should be enclosed in the hose tube. The installation cable should be consistent with the original Vehicle Cable direction, and the installation and wiring along the original trunking of the vehicle,

Tie-up and fix the original vehicle cable to make the wiring neat and concealed to prevent the driver and passengers from breaking it.

Host power cord: The main unit power cord should be pulled directly to the vehicle battery and cannot pass through any switch.

Line type: three-core power cord with a wire diameter greater than 1.0 square millimeters. (The wiring should be staggered to avoid short circuit) The length of the line depends on the model, pay attention to the positive and negative poles of the power supply must be unified, the ACC signal line should be connected with the key fire of the vehicle, and the video line and audio line must be